winzip pro 11.2 command line password switch

(note that while it is advisable to use the same password for all the vty lines that is not a requirement. It would be valid to use different passwords for console and for vty. While it is common to use the same password for both console and vty there is no requirement that they be the same. You need 2 passwords because there are 2 different ways to access the switch. If you use telnet or SSH to access the switch they are accessing the vty lines and use the password configured on the vty. When you access the console you are using a physical cable that connects to the console port of the switch and it uses the configured console password. Why do I have to enter AGAIN the User Mode password on this part? I saw some videos on youtube and everyone is doing the same but I don't really understand this part and will it make a difference if I don't use the same password I set for the User Mode? What is the purpose of this other password?Ī password is related to the way that you will access the switch.

So basically when I am doing the configuration on a switch I have to configure 2 passwords, one for the User Mode and the other one for the Privileged Mode.īut then when I do the configuration for VTY I do this I recently started to study CCNA, I am in the Introduction to networks, there's a command I am a little bit confused and I would like to see if anyone can help me to clarify

Winzip pro 11.2 command line password switch